Fiesta ST Forums banner
inlet
1-7 of 7 Results
  1. Mk6 Engine, Exhaust and Induction
    I am about ready to pull the trigger on an FF Inlet for my ST150 and later would follow the stage 2 Newman cams + map. I have read just about every thread on various sites regarding this upgrade and asked around for information on the other parts that I would need to get this going. The feed...
  2. Mk6 Faults, Problems and Solutions
    Hello, Can anyone tell me what the cables on the top of the engine in the plastic trunking are for? I may have stretched some a bit far and now the car won't turn over Thanks
  3. Mk6 Engine, Exhaust and Induction
    Hello, Iv just recieved my thermal inlet gasket from faraday engineering, it says on the instructions sheet to blank off any exhaust gases that can get to it. Does the ST have an egr? If so how do I delete this?
  4. Mk6 Engine, Exhaust and Induction
    I'm starting to look for an inlet manifold, any suggestions as I don't really want to pay a grand for a cosworth one. Thanks
  5. Mk6 Engine, Exhaust and Induction
    I very nearly bought a cosworth style manifold on ebay the other night until i caught myself on and did a bit of research on the seller! It was a seller from spain which i found weird then asked a few questions to try and get some info, then i found out it was a copy manifold made in china... it...
  6. Mk6 Interior & Exterior | Bodywork & Styling
    I want to paint the Mountune logo on my inlet, just wondered what type of paint I should use because of the heat etc. Cheers Mark
  7. Fiesta ST MK6 Discussion
    Hi guys after decided that it was a go ahead with the mountune....I've recently found out that it's unlikely that they'll be making any more mr200's..well we'll need 20 people to put a deposit down for them to start making the inlet. Now i know it's expensive but i don't mind that. But is it...
1-7 of 7 Results
Top