Fiesta ST Forums banner
light
1-8 of 8 Results
  1. Mk7 Lighting & Electrical
    Looking for some help getting an rpm wire for a shift light. I've done some trawling on the forums and managed to get a rough idea of what is possible with the fiesta's due to them having some ford coil over plug setup or something along those lines that doesn't make it straightforward. I'm a...
  2. Mk6 Faults, Problems and Solutions
    Hi guys, 3 months into ownership of my ST now. Been spot on apart from Lambda sensors/ 02 sensors. Had it in yesterday in the garage as it's being done under warranty. Bank 1 and Bank2 sensor heated circuit was throwing the engine light. Picked it up from my local garage and half way down the...
  3. Fiesta ST MK7 Discussion
    Hi All, I was tinkering with the rear number plate lights (fitting LEDs in place of the standard bulbs) and one of the clips that holds the assembly sprung into the boot lid! I've tried using a magnetic wand type thing but no luck - I think it's in the middle section which is partially blocked...
  4. Group Buys
    This is a group buy for members who would like their lights tinted. We need to build a list of 5 people, for the discount to apply. I have pictures of his work, which are below and the prices for what you would like done is outlined below. He uses Hexis Ultra transparent coloured vinyl...
  5. Mk7 Lighting & Electrical
    Hello guys, I was changing out the interior bulb in the back seats of the car, and as I took off the plastic covering, the switch dropped out as well which has two triangular bits coming off of it. I cant seem to get the switch to sit back in (the light no longer turns on/off, only flickers. Im...
  6. Mk6 Lighting & Electrical
    Hi everyone. I need a bit of info of the type of surface mount LED that is used for the ABS warning light as after about a year of owning my ST I found the ABS system wasn't working. The previous owner had damaged the ABS sensors on the rear. I have since fixed the sensors, ran diagnostics and...
  7. Mk6 Faults, Problems and Solutions
    Hey, I have a Milltek exhaust on my MK6 ST and the engine management light is on. Upon further inspection we found that it had no Catalyst so the sensors were receiving inaccurate information. I purchased a high flow sports cat for it which we fitted no problem. The light went off for about 2...
  8. Mk6 Lighting & Electrical
    Today I fitted my new number plate LED's and they look NICE! Im looking to get the same in the interior as i have seen these on ebay. I was wondering if you can get the two side ones replaced as well or are they the same size? Help appriciated.......................
1-8 of 8 Results
Top